Stage 3 Motorsports 2005-08 Roush Supercharger Cold Air Intakes

Your cart is currently empty

view cart

banners/stage_3_motorsports_project_cars.jpg

R/roush_cold_air_intake_kit_2005_08_supercharger.jpg

New cold air kit for 05-08 Roush supercharged mustangs- Installation Instructions- Before assembling the kit the should make sure that you have all of the following:

Filter Housing

Air Filter

90MM Mass Air Flow Meter

5 Inch Black Silicone Tube

3 Hose Clamps

Billet Adapter Plate

4 Bolts W/Washers

Begin By installing the billet adapter plate onto the filter side of the filter housing. The flange on the adapter should be facing out toward the fender of the car. Next attach the MAF to the opposite side of the housing using the supplied screws. Insert the screws through the MAF and into the holes in the housing where they should thread into the adapter plate. Once the MAF and adapter plate are secured onto the housing it is time to put the air filter on. Place one hose clamp onto the end of the filter (Leaving it loose) and slide the filter onto the end of the adapter plate flange. Once the filter is flush with the adapter plate you should tighten the hose clamp. Finally take the black silicone tube and slide it over the end of the MAF. From there place the two remaining hose clamps on the tube at either end. Tighten the clamp at the side closest to the MAF, then install the other end of the tube to the rest of the intake and tighten the clamp.