2020-2022 Ford F250/F350 4WD Gas BDS 5 inch 4-Link Lift Kit w/ FOX 2.5 Elite Shocks & 4 inch Blocks | 1999FPE

F250/F350 4WD Gas BDS 5 inch 4-Link Lift Kit Features:

• Fits F250 and F350 4WD Gas models
• Provides 5 inches of front suspension lift
• Clears up to 37 inch tires
• Converts radius arms to 4-link system
• 4-link improves strength and axle control
• Gas-specific Pro-Ride dual rate coil springs
• Forged drop pitman arm for steering correction
• Heavy-duty track bar relocation bracket included
• 4-inch rear cast iron lift blocks included
• Compatible with FOX 2.5 Elite shocks upgrade
• Improves stability on and off-road
• Easy bolt-on installation, no cutting required

Add a Big Lift and Bold Stance to your Gas-Charged Super Duty

If you’re ready to give your 2020-2022 F250 or F350 Gas Super Duty a commanding new look without compromising everyday driveability, the BDS 5-Inch 4-Link Lift Kit with FOX 2.5 Elite Shocks and 4-Inch Rear Blocks is the perfect choice. This system is designed to give your truck room to clear up to 37-inch tires, while leveling out its stance and boosting off-road capability. The included 4-inch rear lift blocks keep the rear lift simple and cost-effective, maintaining your truck’s factory leaf springs and load capacity for towing or hauling. This setup makes it easy to get the lift you want while still using your truck for what it was built to do.

FOX 2.5 Performance Elite Shocks for Next-Level Ride Control

What really sets this kit apart is the FOX 2.5 Performance Elite Shocks. These premium shocks offer significantly better performance than the standard NX2 Nitro or FOX 2.0 shocks, thanks to their larger body, external reservoir, and Dual Speed Compression (DSC) Adjusters. With these adjusters, you can fine-tune both low-speed and high-speed compression for a custom feel; whether you’re smoothing out your daily commute or tightening things up for a heavy load or rough trail. Compared to the smaller shocks, the 2.5 Elites manage heat better, provide greater damping control, and help your truck stay planted and comfortable no matter where you drive.

4-Link Conversion and a Fully Engineered Suspension System

At the heart of this system is the BDS 4-Link Conversion, which replaces your factory radius arms with heavy-duty upper and lower control arms. This upgrade improves axle stability and keeps your front suspension geometry in check as the suspension cycles. Combined with gas-specific Pro-Ride dual rate coil springs, a forged drop pitman arm, and a track bar relocation bracket, this system provides excellent on-road handling and predictable off-road performance. The rear block setup is ideal if you want to keep your factory leaf springs, but for those who want even more stability under load, you might consider upgrading to full replacement leaf springs in the future. Either way, this BDS kit gives you a big stance, confident handling, and the durability to tackle whatever comes next.

Vehicle Fitment: 2020, 2021, 2022 Ford F250/F350 4WD Gas Models

Application Notes:

1. Replace pitman arm nut after each removal
2. Overload spacer block UBT4027 (Qty: 4) required for overload springs
3. Front exhaust modification may be required on gas models
4. Use small puller to remove drag link and stabilizer taper
5. Carrier Bearing Drop Kit BDS123402 may be required for 2-piece driveshaft
6. Tremor models will not achieve full advertised lift height
7. Stock wheels not recommended with larger tires
8. Trimming may be needed for 37x12.50 tire clearance
9. Installation requires torque wrench rated to 405 ft-lbs
10. Address Ford Recall 21S31 before installing the lift
11. Fits Single Rear Wheel (SRW) models only