2011-2016 Ford F250 & F350 Dually ReadyLift 4 inch Rear Block Kit | 66-2024

Increase Forward Rake on your Super Duty for Improved Towing and Hauling

Even the powerful 2011 to 2016 F250 & F350 trucks can suffer from rear squat under extremely heavy loads, which can make their handling characteristics subpar when you're hauling around your gear, toys, or whatever else you have in mind. The good news is that ReadyLift's 4" rear block kit is here to give your Super Duty truck the extra rake it needs to haul and tow just about anything without ever having to suffer from rear rake or squat under load. ReadyLift's 4" Rear Block Kit is a drop-in replacement for your Super Duty's stock 3" rear block and come with both new U-bolts and nuts to give you and your truck everything you need to tow and haul that much better.

Cast Iron Rear Blocks with OE-Style Design for Fitment and Function

While most rear block kits are just hunks of metal with some U-bolts, ReadyLift's 4" Rear Block Kit was carefully designed to give your truck some extra rear lift while fitting perfectly and eliminating some of the issues caused by lesser-quality aftermarket rear block kits. Each of ReadyLift's blocks are made from heavy-duty cast iron with an E-coat finish to prevent corrosion. The blocks feature OE-style cast-in center pins and are slightly tapered to provide OE fitment and near-OE driveline function so you don't have to worry about safety or reliability issues down the road. The blocks have bump stop landings and come with a full set of E-Coated U-bolts, as well as new U-bolt nuts and washers. The kit comes with instructions and is extremely straightforward to install.

For SRW Trucks Only: This ReadyLift 4" Rear Block Kit is designed for SRW (single rear wheel) trucks only. It will fit DRW trucks WITHOUT camping or overload springs, however we recommend a carrier bearing drop kit if you plan on going that route. To clarify, this kit will NOT fit DRW trucks with overload or camping rear springs.

Driveshaft Fitment: this rear block kit was only designed to fit Super Dutys with one-piece driveshafts out of the box. Super Dutys with two-piece driveshafts will require carrier bearing modifications.