2018-2020 Ford F150 EGR OEM-Look Front & Rear Fender Flares | 783574

I would have liked to have given this product 5-stars because its the only fender flare I have found that looks good with my lift and wheel/tire set up (3" leveling kit, 33" wheels). But there were two problems I found with them. 1st, the front flares do not match up properly to the indention on the front bumper the same way the OEM fender flares do (or you can make them line up with the indention on the bumper but then you wind up with a gap on the door-facing side). It seems they are making these about 1/2" to 3/4" too long. I can only speak for the 2018-on version, I have no idea if this is an issue with 2015-17 version. Secondly, it is a royal pain to install the rubber gaskets they send with these. Its time consuming and its hard to get them in the right position along the flare trim. That process took much longer than the actual installation time once the gaskets were put on. Outside of those two complaints, I like them. I have been working with EGR to give them feedback and photos, they haven't officially acknowledged the problem yet but I hope they will and make a correction to these so they will be even better moving forward. If you have a 4 to 6" lift and 35" or 37" wheels, you 'll probably be better off with the larger after-market fender flares (like Rough Country etc). But if you have anything between stock to 33" wheels, I think these look much better since they don't overwhelm the fender and don't make your wheels look small like the really big after-market flares do.

ANOTHER GREAT LOOK: Once Installed, these Fender Flares look GREAT !!! They are Amazingly cut to fit the Truck Body... I am Very Satisfied with this Product! Installation Hint: As noted in another Review, Installation of the Rubber Extrusion onto the Fender Flares can be Tedious and Time Consuming... I did this over 2-nites prior to the actual Install. Be sure to wipe down the Flares and use the Alcohol Wipes where intended. Once Prepared, the actual Install took only a couple of Hours... Again, choose a location out of the Sun & Wind, and be sure the Truck Body is Clean!

I was very happy with this product. Very easy to install, like other reviews have mentioned the weather stripping can be a tedious job but not that difficult. I was leery about the rear fender clips but they hold the rear fenders on like glue and i have not worries that they will not fail. Fit was 99% perfect and with my zero offset Method rims it give the perfect amount of tire coverage. These are perfect if you want a suttle look and not the goddie look like other flares. Shipping was very quick and the flares were packed very well with no damage. i

Easy to install look fantastic. I tried the 3m tape factory Ford OEM flares and could not get them to stick on tight with no gaps. Wish I would have just started with these.

Easy installation and looks amazing. I watched the video provided on this link.