2005-2014 V6/GT/GT500 BMR Driveshaft Safety Loop (Rear) DSL011

Steeda Driveshaft Safety Loop

Driveshaft safety loops are one of those little things that people don't think about much, but they can save you and your Mustang from serious damage. In high horsepower/torque drag cars it is not uncommon for the driveshaft's front and/or rear U-joints to break due to the demands of high-performance conditions. A broken U-joint at high speeds can pole-vault your Mustang with you inside, creating a dangerous life-threatening situation. You'd be a lot better off staying safe and spending a little bit of money now on BMR's Driveshaft Safety Loop than spending time in the hospital later.

Created For High-Speed Racing

If your Mustang runs 12.99 or quicker in the quarter mile, a driveshaft safety loop isn't just a good idea, it's actually required by NHRA rules. BMR's twin rail construction is designed to remain durable under high-speed racing conditions and the two-piece loop feature means you don't have to drop your Mustang's driveshaft to install it. It will clear a 4" driveshaft and works with both 1 and 2-piece driveshafts.

Fitment:

• 2007-2014 Ford Mustang GT500 Shelby
• 2005-2014 Ford Mustang GT V8
• 2005-2014 Ford Mustang V6

Front Safety Loop Available: Stage 3 also carries the BMR Front Safety Loop (DSL010) that is sold separately for the 2005-2012 Mustang.

Installation Notes: BMR's Rear Driveshaft Safety Loop installs in factory mounting locations, so no drilling or welding is required. Care must be taken at full suspension droop when used with one-piece drive shafts.