2009-2013 Ford F150 4WD Eibach Pro-Lift Front Coil Springs - 2" Lift | E30-35-002-02-20

2009-2013 F150 4WD Eibach Pro-Lift Front Coil Springs - 2
2009-2013 F150 4WD Eibach Pro-Lift Front Coil Springs - 2' Lift
SKU E30-35-002-02-20
3 Review(s)
$275.00
18 in stock Ships in 1 Business Day
Free shipping included
60-day returns on most items
Earn reward points with this purchase
Write a Review
Average Rating
2014 F150 Lariat 4x4
I took a gamble and installed these on a 2014 on the lowest perch setting on a set of Bilstein 5100's (only rated for 09-13's). Got around 2.5 of lift. Ride is excellent and handling is much improved over the spacer I had previously. Ride is similar but better than the Bilsteins with the stock spring on the highest perch setting. Low speed bumps can be a little rough, but overall this is a great setup. I just installed a set of Fox 2.0's and on a friends 2014 and this is an equivalent setup for roughly half the cost. One note of caution is to have a real spring compressor, not the cheesy one you get on ebay or rent from the auto parts store. I tried assembling the strut in my garage, but had to have a shop do it with a Branick. I also installed a set of new UCA's since I figured the lift would be over 2 and I would highly recommend that.
Did you find this helpful?  19 of 19  Found Helpful
Reviewed by:  from San Antonio on 12/19/2018
5
Average Rating
2012 F150 XLT
Paired with Bilstein 5100's SPC UCA'S Ready Lift 1.5 rear springs with Bilstein 5160's Raptor SVT Rims 33" General Grabber ATX's Drives great and everything fit very well. Very pleased.
Did you find this helpful?  4 of 4  Found Helpful
Reviewed by:  from Poland on 5/8/2020
5
Average Rating
2012 F150
I bought these Eibach leveling springs along with the Eibach Complete Pro-Truck Sport Shock & Strut Kit. All I can say is hands down better than the Bilsteins I had on before better ride and handling with this setup. Would highly recommend it to anyone looking for a great ride on and off road.
Did you find this helpful?  0 of 2  Found Helpful
Reviewed by:  from Folsom on 10/8/2020
5
Load More

Customer Question Can these springs be used on a 2014 model?

Asked by: Hector - 3/31/2023
Customer Answer Unfortunately, Eibach has not confirmed fitment of these springs on the 2014 F150s.
Was this answer helpful?  0 of 0  Found Helpful.
Answer provided by: Jason@Stage3 (4/3/2023)

Customer Question I am ordering the 4wd pro leveling struts. I want to combine with the springs. I am reading I can get a total lift of approx. 2.7 inches. Where does the perch need to sit to get to 2.7 inches. I currently have 3 inch level spacer and want to come down a touch but still need to clear my 35's. Thanks

Asked by: Anthony - 8/26/2022
Customer Answer The springs on their own add 2.5" of ride height. To hit 2.7" of ride height, you'd have to set your Eibach Pro-Lift Struts to .7" of ride height.
Was this answer helpful?  0 of 0  Found Helpful.
Answer provided by: Jason@Stage3 (8/29/2022)

Customer Question Will these fit the 2011-2014 Raptor?

Asked by: richard saragosa - 8/21/2022
Customer Answer They will not. For options for the 2010-2014 SVT Raptors, give us a call directly at 623-434-5277 or email us at [email protected].
Was this answer helpful?  0 of 0  Found Helpful.
Answer provided by: Jason@Stage3 (8/22/2022)

Customer Question I am replacing a 2.5 leveling spacer with these and the eibach struts. What setting on the struts will get me closest to that height? I also have a larger 120lb front replacement bumper (ranch hand replacement bumper).

Asked by: Joshua - 5/25/2021
Customer Answer Your best bet would probably be the .7" ride height setting, though it's tough to say whether you'll be at an exact 2.5" of ride height after everything's said and done.
Was this answer helpful?  0 of 0  Found Helpful.
Answer provided by: Jason@Stage3 (5/26/2021)

Customer Question An these be paired with bilstein 5100s on my 2013 f150 4x4? Also, can I go up to the second porch sting for .75" when I install these so I get a total of 2.75"? This says lowest only then it says it can be lifted up 1 setting.

Asked by: Jc - 5/13/2020
Customer Answer They can be. You can use these springs at the .75" perch settings on the Bilstein 5100s. That being said, that's pretty high for the stock UCAs, and you may want to consider upgrading.
Was this answer helpful?  1 of 1  Found Helpful.
Answer provided by: Jason@Stage3 (5/14/2020)

Customer Question I have a 2012 Ford FX4. I am in need of new front struts and springs, one is broke, and I am interested in these with either Bilstein or Eibach. I currently have a 2 1/2" spacer for level. With these springs and the shock in the +.75 is that going to give me 2.75 or 2"?

Asked by: Bob - 4/11/2020
Customer Answer You should be at 2.75"-ish of ride height. The springs along add 2" of height, so the additional height of the perch setting just adds to that. Just keep in mind that you may be a smidge higher than that while the springs break in.
Was this answer helpful?  0 of 0  Found Helpful.
Answer provided by: Jason@Stage3 (4/13/2020)

Customer Question can these be used with the bilstien leveling struts?

Asked by: opel - 3/12/2020
Customer Answer You can, though the ride height guidelines still apply, since these springs add 2" of front leveling on their own. We only recommend using the springs up to the +.75" ride height mark on the Bilstein 5100s.
Was this answer helpful?  0 of 0  Found Helpful.
Answer provided by: Jason@Stage3 (3/13/2020)

Customer Question Why can these springs not be use with the stock struts ? The eibach struts fit the stock springs. It would make sense that these eibach springs would fit the stock struts also?

Asked by: Joe - 11/14/2019
Customer Answer According to Eibach, while the springs will likely install fine, you'll probably end up with pretty poor ride quality, since the stock struts will be bouncing off their internal limiters, which also leads to premature wear.
Was this answer helpful?  0 of 0  Found Helpful.
Answer provided by: Jason@Stage3 (11/20/2019)

Customer Question Do these Eibach springs come in a higher spring rate? I see that the Fox/Boss/Halo coil overs all seem to come with Eibach springs but they are closer to 700 lbs spring rate where these are rated at 525 lbs. What kind of springs come on the Bilstein 6112? I have a set of uninstalled Bilstein 5100 for my 2011 Fx4 and am looking to replace the factory springs when installing the struts to further enhance the ride. I ride mostly on road but do hit the sand dunes and trails a few times a year. Will these springs with the 525 lbs spring rate do the trick, or should I look for ones with higher spring rates? The springs will be mounted on the 5100s on the lowest perch setting, I'm hoping by ditching the spacer lift I currently have will improve the ride and handling with the new strut/spring combo. Also, is it recommend to change out the struts mounts when replacing shocks and springs?

Asked by: Scott - 8/13/2019
Customer Answer You have to keep in mind that spring rate is only one factor when it comes to both ride quality and performance. These springs' 525in-lb rate is tuned to get their rated ride height and to stay fairly pliant on the street. The 6112s use springs with a 500in-lb spring, and neither the 6112 or Boss springs can be swapped over to the 5100s due to different lengths and diameters. Eibach's springs will work fine on the street and during general off-roading. If you believe you need a something more aggressive, give us a call directly at 623-434-5277.
Was this answer helpful?  1 of 1  Found Helpful.
Answer provided by: Jason@Stage3 (8/14/2019)

Customer Question Kind of dumb question but, is the price for 2 springs or am I buying them separately?

Asked by: Edgar - 1/28/2019
Customer Answer This price and part number is for a pair of springs.
Was this answer helpful?  2 of 2  Found Helpful.
Answer provided by: Jason@Stage3 (1/29/2019)

Customer Question Will these springs fit a 2wd?

Asked by: Drew - 12/28/2018
Customer Answer Unfortunately, they will not.
Was this answer helpful?  0 of 0  Found Helpful.
Answer provided by: Jason@Stage3 (1/3/2019)

Customer Question Is there any update on the fit for 2014's?

Asked by: Curtis S - 11/13/2018
Customer Answer Unfortunately, Eibach does not have a part number specific to the 2014 F150s as of yet, and they have not confirmed fitment of this part number either.
Was this answer helpful?  1 of 1  Found Helpful.
Answer provided by: Jason@Stage3 (11/14/2018)

Customer Question I assume the price is for the pair of springs? I am unhappy with my icons at factory sent 2". Every little bump is harsh up to 35+ mph. Looking at a setup better suited for a daily driver/slow bumpy forest roads. Do you have any comparison between these and the icons?

Asked by: Billybob - 9/28/2018
Customer Answer These springs will not fit ICON coilovers. They are only designed to fit aftermarket strut assemblies that reuse the factory springs (Eibach Pro-Trucks, Bilstein 5100s, etc.). Your best bet would be to call us directly at 623-434-5277 for possible solutions.
Was this answer helpful?  0 of 0  Found Helpful.
Answer provided by: Jason@Stage3 (10/1/2018)

Customer Question I understand these springs are compatible with the Bilstein 5100 adjustable front struts as well, and the product features section list they are to be used on the lowest perch setting on the Eibach struts for 2" of lift. Does this apply directly to the 5100 strut as well, or will I see a different lift height with the lowest perch setting utilized with these springs?

Asked by: Chris - 8/29/2018
Customer Answer These springs will work on the Bilstein 5100s, though you will have to use them on the lowest perch setting to get 2" of lift, since the Eibach and Bilstein strut assemblies feature a similar design.
Was this answer helpful?  2 of 2  Found Helpful.
Answer provided by: Jason@Stage3 (8/30/2018)

Customer Question I have a 2014 Ford F-150 4wd. I am interested in the profile lift kit shocks you have for my truck. My question is, if the only thing that changed with the 2014 front shocks(E60-35-035-02-10) and the 2009-2013 (E60-35-002-02-10) were the mounting brackets on the lower end of the shock, why are the 09-13 pro kit springs(E30-35-002-02-20) not compatible? Is the spring lower pearch different or is the factory upper shock body mount different? Thanks Michael

Asked by: Michael - 5/8/2018
Customer Answer Unfortunately, I don't have a solid answer from Eibach. This set of springs is only confirmed to fit 2009-2013 F150s. Whether it's because of a minor change in spring perches or just Eibach not outright confirming it on a test truck, we're not sure. A set of 2014-specific springs should be available here in the near future.
Was this answer helpful?  1 of 3  Found Helpful.
Answer provided by: Jason@Stage3 (5/9/2018)

Customer Question Would these work on 2014's as well? I want to match them with the 5100's I purchased.

Asked by: Bill C. - 5/2/2018
Customer Answer Unfortunately, Eibach only lists their fitments 2009-2013. Hopefully we'll see a 2014 part number here soon.
Was this answer helpful?  1 of 3  Found Helpful.
Answer provided by: Jason@Stage3 (5/3/2018)
Load More
Earn reward points
on this product

Stage 3 Rewards is our free customer loyalty program. Earn points on every order and redeem for cash off your next purchase.

  • 100 bonus points just for signing up ($2 to start)
  • 1 point per dollar spent on every order (2% back)
  • Bonus points for reviews, birthdays, and social shares
  • Redeem for $10, $20, $30, $50, or $100 off coupons
See full program details

WARNING: Cancer and Reproductive Harm

This product can expose you to chemicals including those known to the State of California to cause cancer and birth defects or other reproductive harm.

For more information, visit [www.p65warnings.ca.gov](https://www.p65warnings.ca.gov).

Pick Up Where You Left Off

Logo