Our good friend Kyle, formerly a local Arizona customer now living in Texas, ordered up a set of Fiberwerx Flared One-Piece Fenders and a Fiberwerx Front Valance for his 2012 5.0L F150. The fenders perfectly compliment the rest of Kyle's extremely aggressive exterior upgrades which include a LEX Gen 3 Front Off-Road Bumper, a Lex Gen 2 Rear Bumper, a customized LEX Half Chase Rack, Rancho QuickLift Leveling Struts, and 35" General Grabber Red Letter tires. Kyle's truck was already looking pretty radical before he threw on the Fiberwerx Fenders, and now it's looking utterly amazing. Installing the fenders is a bit of of bear, but Kyle did a good job of illustrating the whole process in the images he sent over.
Fiberwerx's Fenders do require the removal of a lot of your stock hardware, and even require drilling into the fenders themselves in order to get them on the truck. However, this isn't all bad, as drilling your own holes means you can line the fenders up as needed, especially on F150s that have been in accidents or have some slight tweaking from jumps or rough terrain. Check out the images below for a bit of Kyle's installation progression.
