Rotor Size: Factory rear 13.70" and front 13.78" replacements.
This brake kit will only fit trucks with 6-lug hubs.
For 2015 F150s with Manual Parking Brakes only: this brake kit will only fit 2015 F150s with manual parking brakes, and will not fit F150s with electronic parking brakes. Please ensure your F150 has a manual parking brake before ordering. A version for F150s with an electronic parking brake is under development.
Check out our install guide of this brake kit on our 2012 F150 5.0L FX4 Project Truck!
Power Stop Extreme Bedding Note: The break in procedure is critical to brake performance. The reason for a proper break in is to establish an even layer of friction material deposited on the rotors from the brake pads. It is very important that this initial layer of friction material is evenly distributed. Break in the pads as follows: 5 moderate to aggressive stops from 40 mph down to 10 mph in rapid succession without letting the brakes cool and do not come to a complete stop. Then do 5 moderate stops from 35 mph to 5 mph in rapid succession without letting the brakes cool. You should expect to smell some resin as the brakes get hot. After this is complete, drive around for as long as possible without excessively heating the brakes and without coming to a complete stop (Try for about 5 minutes at moderate speed). This is the cooling stage. It allows the heated resin in the brake pads to cool and cure. After the brakes have cooled to standard operating temperature, you may use the brakes normally.