2015-2020 Ford F150 & Ford Raptor RPG Stage 1 Rear Suspension System | RBPA0001_2.5

Highlights:

• Increases rear frame strength and adds bump stop mounts
• Durable steel construction with black powder coat finish
• Includes mounts for 2.5" bump stops
• Installs without bed removal
• Requires rear block modifications

Improves Rear Frame Strength and Comes with 2.5" Bump Stop Mounts

One of the big weak points of F150s and Raptors that are going to see serious off-road use is the rear frame under the bed which has been known to both bend during violent and aggressive off-roading and jumping. RPG's Stage 1 Rear Suspension System seeks to remedy the situation while leaving you room to expand with a set of 2.5" bump stop mounts. The Stage 1 Suspension System consists of a full rear frame cross brace that adds strength and frame stiffness to your aggressive F150 or Raptor build so that you can push it to the limit when you head off the beaten path. The Stage 1's cross brace comes fitted with two 2.5" bump stop mounts and sits in-line with the rear axle so that you can mount up a set of air or hydraulic bump stops down the road.

Strong Steel Construction with Black Powder Coat Finish

The Stage 1 System is an excellent way to add the strength and support your Raptor or F150 needs to really rip around off-road. The Stage 1's cross brace is made out out of thick steel that's topped off with a black powder coat finish that provides corrosion protection and a clean look with the rest of your truck's frame. The Stage 1's modular design with a separate brae rail and bump stop mounts allow for the installation of the entire kit without needing to remove your Raptor or F150's bed. The Stage 1 System comes with all its necessary installation hardware and instructions. The two bump stop mounts can accept most 2.5" diameter bump stops from major manufacturers.

Fitment:

• 2015, 2016, 2017, 2018, 2019, 2020 F150
• 2017, 2018, 2019, 2020 Ford Raptor

Block modifications required: this kit requires grinding down the locating nubs on the stock blocks and drilling into the factory blocks for installation.