2017-2020 Ford Raptor RPG 3 inch Lift Coil Spring Perch Collar | Part# RBPA0042

Highlights:

• Provides extra ride height in a simple kit
• Adds 3" of height in an easy install
• CNC machined billet aluminum
• Blue anodized finish that matches stock colors
• Installs without coilover disassembly
• Requires spring compressor
• Made in the USA

Adds 3" of Front Leveling in an Easily-Installed and Low-Cost Package

Unlike the 2010-2014 SVT Raptors, the 2017-2020 Raptors don't have adjustable perch settings for their front coilovers, which makes it a bit tougher to add some extra ride height to the front end of your 2017-2020 Raptor. RPG is here to help with their 3" Lift Coil Spring Perch Collar. This collar installs onto your Raptor's factory coilover assemblies below it's coil springs and doesn't even require the complete disassembly of the stock coilover assemblies. This version of RPG's Spring Perch Collar adds 3" of front height to your Raptor's front end, which is enough to give your Raptor a clean, leveled stance and make some room for aftermarket wheel and tire combinations. The RPG Perch Collar is made out of high-quality materials and comes with install instructions.

CNC Machined Billet Aluminum with a Blue Anodized Finish that Matches the Stock Coilovers

Each Perch Collar was designed for a straightforward installation and is built tough so that it won't let you down while you rip your Raptor around off-road. The RPG Spring Perch is made entirely out of CNC machined billet aluminum that's topped off with a blue anodized finish that matches the finish of the factory Fox coilover assemblies for a seamless look on your Raptor. The Perch Collar installs around the stock coilover in place of the stock spring perch and isolator, effectively moving up the perch and spring to add ride height. The collar does not require the complete disassembly of the stock coilover, though you will need a spring compressor to compress the stock coil spring. Each spring perch collar is made right here in the USA and comes with RPG lettering and American flag.

Fitment: 2017, 2018, 2019, 2020 Ford Raptor

Spring Compressor Required: while installation does not require the total disassembly of the stock coilover, install does require compressing your Raptor's spring which necessitates using a high-quality spring compressor. We recommend using either a floor mount or wall mount spring compressor.