Fitment:
Power Stop Extreme Bedding Note: The break in procedure is critical to brake performance. The reason for a proper break in is to establish an even layer of friction material deposited on the rotors from the brake pads. It is very important that this initial layer of friction material is evenly distributed. Break in the pads as follows: 5 moderate to aggressive stops from 40 mph down to 10 mph in rapid succession without letting the brakes cool and do not come to a complete stop. Then do 5 moderate stops from 35 mph to 5 mph in rapid succession without letting the brakes cool. You should expect to smell some resin as the brakes get hot. After this is complete, drive around for as long as possible without excessively heating the brakes and without coming to a complete stop (Try for about 5 minutes at moderate speed). This is the cooling stage. It allows the heated resin in the brake pads to cool and cure. After the brakes have cooled to standard operating temperature, you may use the brakes normally.
Stage 3 Rewards is our free customer loyalty program. Earn points on every order and redeem for cash off your next purchase.
WARNING: Cancer and Reproductive Harm
This product can expose you to chemicals including those known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information, visit [www.p65warnings.ca.gov](https://www.p65warnings.ca.gov).
