Fitment:
Rotor Size: Factory rear 13.39" and front 13.66" replacements.
Power Stop Extreme Bedding Note: The break-in procedure is critical to brake performance. The reason for a proper break-in is to establish an even layer of deposited friction material on the rotors. It is very important that this initial layer of friction material is evenly distributed. Break in the pads as follows: five moderate to aggressive stops from 40 mph down to 10 mph in rapid succession without letting the brakes cool and without coming to a complete stop. Then five moderate stops from 35 mph to 5 mph in rapid succession without letting the brakes cool. You should expect to smell some resin as the brakes get hot. After this is complete, drive around for around five minutes without excessive braking and without coming to a complete stop. This is the cooling stage -- it allows the heated resin in the brake pads to cool and cure. After the brakes have cooled to standard operating temperature, you're good to go.
